Corner Sensor (Special Specifications Vertical Surface Adsorption Type) 2-Axis Separate Type Inclinometer SEC-S011F-Parking
The adsorption type inclinometer for corner sensor vertical angle measurement is an inclinometer in which the sensor and monitor are separate systems, lightweight, and can be adsorbed on a vertical measurement site.
It can be adsorbed on a corner sensor on a soft bumper to measure the vertical inclination angle.
In the past, the inclinometer was often positioned by hand by pressing the measuring section against the bumper, but in this case, the positioning may be unstable or the measured value may not be accurate due to deflection of the bumper.
A small suction pump is used to generate a constant negative pressure, which is then adsorbed by a stable force to the vertical surface to enable accurate angle measurement.
Features
01 Lightweight tilt angle sensor
02 Vacuum suction pad incorporated into the tilt angle sensor
03 Ultra-compact vacuum pump adsorbs the sensor unit, enabling stable pitch angle measurement.
04 2-axis measurement capability enables measurement of tilt angle in the roll direction orthogonal to the pitch angle.
05 By setting the roll angle range (*), stable pitch angle measurement is possible within an arbitrary roll angle range.
※ Set the angle range in the mode settings (e.g. ±1.0 degrees), and if the angle falls within that range, the LED will light up, etc.
06 Accuracy(repeat)±0.1degrees(in the range of±10 degrees)±0.15degrees(in the range of+10~45 degrees or -10~-45 degrees)
Spec
Measuring range | ±45.0 degrees |
Accuracy (repeat) | ±0.1 degrees (±10.0 degrees) |
Resolution | 0.01 degrees |
Response Speed | Approx. 200ms or less |
Power source | Ni-MH rechargeable battery 12V 2200mAh |
Operating temperature/humidity range | 10 to 40°C (theoretical), 25 to 85%RH (no condensation) |
Storage temperature/humidity range | -10 to 75°C (theoretical), 20 to 90%RH (no condensation) |
Sensor mass, dimensions | Adhesive pad type 40g |
Monitor section weight, dimensions | W138✕H69✕D190 (mm), 1.2 kg (including batteries) |